Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Richmond?
Spring repair in Richmond typically runs $180 to $340 for a single spring, and that price is for one spring, not a pair. Most doors carry two torsion springs that share the load, and when one lets go the second is usually right behind it, so a matched pair is normally replaced together and runs about double that range. The written estimate you get on site sets the final price, and the visit itself is free.
A broken spring means the door won’t lift, or worse, drops the moment the opener tries to raise it. It’s one of the few garage door failures we tell people never to test by hand. Our technicians have up to 11 years of experience on this exact job, and spring replacement is a named service here, not something squeezed in between other trades.
Call (866) 490-7906 for a free estimate. We answer 24/7.
Key Takeaways
- One spring: typical estimate $180 to $340. A matched pair: roughly double.
- Most of the price is the spring itself plus the labor to wind it safely under load.
- Bearing plates, drums and cables add cost when they’re worn alongside the spring.
- Sizing matters: springs are matched to door weight, so the wrong wire size chews through itself.
- Estimates are free, same-day service is often possible, and fast dispatch from 7am to 7pm, Sunday through Friday, gets a technician out to Richmond homes.
Spring Replacement Cost Breakdown (2026)
Richmond pricing breaks down neatly by what part of the spring assembly has to come apart. These are typical estimates for the metro area, and they assume the door is otherwise sound. If the opener, cables or panels are also failing, the total moves.
| Spring work | Typical estimate |
|---|---|
| Torsion spring replacement, one spring | $180 – $340 |
| Torsion spring replacement, matched pair | About double the single-spring range |
| Extension spring replacement (per spring) | $180 – $340 |
| Cable repair (often needed with a spring) | $130 – $250 |
| Track realignment (door twisted off level by a snapped spring) | $120 – $240 |
| Roller replacement (while the door is down for the spring job) | $110 – $220 |
| Opener repair (when the motor has been straining against a broken spring) | $120 – $320 |
| General garage door repair (mixed hardware job) | $150 – $600 |
| Panel replacement (if a dropped door bent a section) | $250 – $500 |
| New door installation (if the door is beyond another repair) | $700 – $2200 |
| Opener installation | $250 – $550 |
The single biggest driver is the spring itself: wire gauge, inside diameter and length all have to match the door’s weight, and a heavier or wider Richmond door takes heavier springs. Two-car doors with a single span and a lot of insulation weigh considerably more than a plain one-car door, and that weight is what the springs are wound to carry. The second driver is what the failure took with it. A spring that snaps at speed often kinks a cable or knocks a roller out of its track, and both get priced in because the door won’t run true until they’re fixed. Labor is the rest, and it’s higher when the assembly is seized from years of grit or when a previous repair left the wrong springs on the door.
Anyone who quotes you without checking wire size, door weight and the number of cycles the spring is rated for is guessing. We check all three before naming a figure.
What Affects Spring Replacement Pricing in Richmond
- One spring or two. A single broken spring can be replaced alone, but if the second is the same age and the same wire, replacing both in one visit costs less than two separate jobs down the line. We’ll tell you which makes sense for your door.
- Door weight and size. A double-wide insulated door in a Henrico County garage carries far more tension than a standard single. Heavier the door, heavier the spring, higher the price.
- Torsion versus extension. Torsion springs sit above the door on a shaft and carry more load safely; extension springs run along the sides. Torsion work is the more involved of the two, and both are handled here.
- Spring cycle rating. Springs come in standard and high-cycle versions. The high-cycle spring costs more up front but lasts longer before it fatigues, which is worth knowing if your door runs several times a day. Richmond households with two cars coming and going wear springs faster than a one-driver home.
- Condition of the rest of the assembly. Cables, drums, bearing plates and center brackets all take load alongside the spring. A rusted or cracked plate adds to the job because it can’t safely be reused.
- Springs on hand versus ordered. Common sizes for standard residential doors are widely stocked, so most Richmond jobs get done same day. Odd sizes for older or oversized doors may need a specific spring brought in.
- Your door’s brand. We service equipment from Clopay, Amarr, Wayne Dalton and Raynor on the door side and LiftMaster, Chamberlain, Genie and Craftsman on the opener side, so if your door is a common residential brand we already know what spring assembly sits on it.
Why Spring Replacement Isn’t a General-Handyman Job
A torsion spring sits wound under serious tension, and the tools that hold it are doing dangerous work every second the job is underway. A spring that lets go under a hand or a winding bar causes real injuries. That’s why we tell homeowners plainly: the diagnosis you can do yourself by eye, but the replacement needs a trained technician with the right bars, the right technique and the right spring.
What you can safely check is simple. Look at the spring above the door, or the pair of springs running along the sides. A clean break, a gap in the coil, or a spring sagging out of shape means it has failed. From inside, if the door feels dead heavy when you lift it by hand with the opener disconnected, the spring is likely the reason. What you should never do is try to wind, unwind, or reposition a spring, or reach into the assembly while the door is under tension. Leave it to the professionals.
General handymen often pass on this job because of the liability and the tools involved. Garage doors are all we do, from the opener to the panel to the spring, and spring repair is offered here as a dedicated service rather than a side task. If you want the fuller picture on how a replacement actually works, our guide on Richmond Garage Door Repair Experts walks through the whole process.
What Happens When You Call
When a spring breaks, the door won’t open. If the car is trapped or the door is stuck open and leaving the house exposed, that’s an urgent call, and we treat it that way. Emergency garage door service is a core offering here, not an upsell bolted onto the side.
Here’s the shape of a typical call:
- You call (866) 490-7906. We answer 24/7, and the person who picks up will walk through what the door is doing so we can prepare the right part.
- We book the visit. Fast dispatch, 7am-7pm, Sunday through Friday, puts a technician on your job, and same-day service is often possible.
- On site, the technician confirms the failure, checks the cables, drums and plates, matches the spring to your door’s weight, and gives you a written estimate before any work starts.
- The work is done with the door secured and the opener re-tested. You get the door back up and running today in most cases.
A note on the opener: when a spring is broken and someone keeps pressing the remote, the opener tries to haul the full weight of the door alone. That’s how a $180 spring repair turns into a spring plus opener repair at $120 to $320 more. If your door won’t lift, stop using the opener until it’s checked.
We prefer to book the work for a day we’re on site, which is Sunday through Friday. If you call on a Saturday, we’re closed that day, and we’ll book you in for the next opening.
How to Save on Spring Replacement
Saving on a spring job comes down to doing it before the second one fails and before the failure damages anything else. A few practical moves for Richmond homeowners:
- Fix both springs together. Springs are usually replaced as a matched pair because they wear at the same pace. Two in one visit is cheaper than two separate visits, and it avoids a repeat breakdown a month later.
- Ask about cycle rating up front. A high-cycle spring costs more on the estimate but lasts longer. If your door cycles many times a day, that’s a real saving over the life of the door.
- Get the rollers and cables checked in the same visit. Labor as part of a spring job is a smaller line than a separate callout for the same hardware.
- Stop running the opener after a failure. A broken spring plus a burned-out opener motor is the expensive version of the same problem. The cheapest repair is the one you do before the collateral damage.
- Get a written estimate before work starts. Free estimates mean you know the number before the technician touches the door. Call (866) 490-7906 to book one.
We don’t sell maintenance plans or bundle deals. The price is set per job by the written estimate, and the estimate is free.
Spring Replacement vs. New Door: Which Makes Sense?
In most cases the spring is the cheap fix and the door has plenty of life left in it. A spring replacement lands in the $180 to $340 range for one spring, roughly double for a pair. A new door installation runs $700 to $2200. That gap is wide enough that a new door should only come into play when the door panel itself is bent, rusted through, or has been dropped hard enough to damage sections.
If the door is sound and the opener is failing, that’s an opener repair at $120 to $320, or an opener installation at $250 to $550 if the unit is old enough to retire. If a dropped door bent a panel, panel replacement at $250 to $500 can be cheaper than a full door. We check the whole assembly before recommending anything, because the last thing we want is to sell a door to someone who needed a spring.
The Richmond Climate and Your Springs
Richmond summers are humid and hot, and that humidity is hard on the steel in a torsion spring. The wire shifts through thousands of cycles, and constant moisture accelerates the corrosion that starts fatigue cracks on the coil’s surface. Winters bring cold snaps that make metal brittle, which is why spring failures often cluster around the first hard freeze and the first hot stretch of summer.
Homes with attached garages that run damp tend to see springs go sooner than dry, well-vented ones. You can’t stop the climate, but keeping the garage dry, checking the springs by eye twice a year, and replacing a matched pair instead of one at a time all push the next failure further out. A little grit and rust on the spring is normal; a gap, a kink or a piece missing is not.
FAQs – Spring Replacement Cost
How much does garage door spring replacement cost in Richmond?
Spring replacement in Richmond typically runs $180 to $340 for one spring, and a matched pair costs about double that. Cables, drums and tracks, if they need work too, add $120 to $250 each. Call (866) 490-7906 for an exact quote, and estimates are free.
Should I replace one spring or both?
Most homes replace both springs at once, because they wear together and a second failure a few weeks later means paying for a second visit. If your springs are the same age and wire, replacing the pair in one trip is usually the better value. We’ll tell you what we see on the door before any work starts.
Why is one spring cheaper than a pair?
Because a single spring range only covers one spring. A door with two torsion springs is carrying its load across both, so a matched pair is two springs plus the labor to wind and balance both. A pair is about twice the single-spring range, not the same price.
Can a broken spring be repaired the same day?
Often, yes. Standard residential door springs are common sizes and most replacements get done in a single visit, so your door is back up and running today in most cases. Fast dispatch from 7am to 7pm, Sunday through Friday, gets a technician out, and calling early gives you the best shot at same-day service. Call (866) 490-7906 to book.
Is it cheaper to repair the spring or replace the door?
Repairing the spring is far cheaper in almost every case: $180 to $340 for one spring versus $700 to $2200 for a new door installation. A new door only makes sense if the panels are damaged beyond a $250 to $500 panel replacement or the door has structural problems. We check the whole door and tell you which one fits your situation.
Can I replace the spring myself?
For a torsion spring, no. The spring is wound under heavy tension and held by bars, and a slip can cause serious injury. The diagnosis you can do by eye, but the replacement belongs with a trained technician. Call (866) 490-7906 and we’ll handle it safely.
What if my door won’t open at night or early morning?
Call (866) 490-7906. We answer 24/7. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm.
Get a Free Spring Replacement Estimate in Richmond
A broken spring is a same-week problem at worst and often a same-day one. Whether it’s a single torsion spring, a matched pair, or a snapped extension spring on an older door, we’ll give you a written estimate before any work begins, matched to your door’s weight and your opener’s setup. Richmond Garage Door Repair Experts handles the door, the opener and the spring, so you don’t need a second vendor for any of it.
Call (866) 490-7906 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Back up and running today is the goal on every call.
Pricing reflects the Richmond market as of 2026. Richmond Garage Door Repair Experts offers free estimates – call (866) 490-7906.
What Our Customers Say
"Spring snapped at six in the morning with my car sealed inside and me due at work. Somebody was here by eight thirty and had it fixed that morning. Door's quieter now than it was before it broke."
- Rafael Salazar"Opener kept reversing halfway down. Turned out to be the safety sensors knocked out of alignment by a bicycle. He straightened them, wouldn't charge me for it, and just asked me to keep them in mind if I need real work later."
- Emily Anderson"Replaced the bottom panel after I backed into it. Color match is close enough that you have to know to look for it."
- Vivian Wong